TB-9-2510-251-13

TECHNICAL BULLETIN

OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING

AUGUST 2007

TB-9-2510-251-13 - Page 167 of 624

2-151

TB 9-2510-251-13

24

26

22

23

25

27

2-2.1

Installation of Air Conditioning Kit to M998 and M998A1; M1037; M1097 and M1097A1

Two-Door with O’Gara Hess Add-on-Armor (Cont’d).

a. Install Compressor (Cont’d)

WARNING

Solvent used to clean parts is potentially dangerous to personnel and property.

Clean parts in a well-ventilated area.

Avoid inhalation of solvent fumes.

Wear

goggles and rubber gloves to protect eyes and skin.

Wash exposed skin

thoroughly.

DO NOT smoke or use near open flame or excessive heat.

Failure to

observe this warning could result in severe injury or death to personnel.

Figure 2-226.

Adjusting Arm Installation

(19)

Clean mounting surface where adjusting arm mounts to water pump housing with solvent

(item 10, Appendix D).

(20)

Secure adjusting arm (22) to water pump housing with bolt (23), lockwasher (24),

washer (25), adjusting arm (22), and spacer (26).

(21)

Adjust tension on belt (27).

Rotate compressor outboard until proper belt tension is

reached.