TB-9-2510-251-13
TECHNICAL BULLETIN
OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING
AUGUST 2007
TB-9-2510-251-13 - Page 21 of 624
2-5
TB 9-2510-251-13
2-1.1
Installation of Air Conditioning Kit to M998 and M998A1; M1037; M1097, and M1097A1
with GSIE Add-on-Armor (Cont’d).
a. Install Compressor (Cont’d)
(2)
Compressor Mounting.
a. Mark air intake duct at the air filter housing.
Remove air intake duct.
b. Loosen alternator and power steering pump belts.
c.
Slip belts off alternator and power steering pump pulleys.
(3)
V-belts: Disconnect fan clutch hose to remove belts.
a. If the vehicle will be upgraded to use a 200 amp alternator and three forward belts are
to be used to drive the alternator, one new longer belt will be used for the power
steering pump and the air conditioning compressor.
Remove the existing power
steering belt(s) and replace with new longer belt.
b. If only the two forward belts will be used for the alternator, the power steering pump will
be driven by one new longer belt.
Remove only one power steering belt and install the
longer belt on rear most pulley groove.
c.
Reconnect fan clutch hose.
AIR INTAKE DUCT
3
4
1
2
Figure 2-1.
Air Intake Duct Removal
Figure 2-2.
Fuel Line and Wiring Harness Clamp Removal
(4)
Remove clamps (1).
Attach fuel line (2), fuel return line (3), and wire harness (4) to engine.
Set hardware aside for future use.
Back to Top
