TB-9-2510-251-13
TECHNICAL BULLETIN
OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING
AUGUST 2007
TB-9-2510-251-13 - Page 27 of 624
2-11
TB 9-2510-251-13
1
1
2
(3)
Position drill template (found in Installation Kit) on transmission tunnel and tape into
position.
Drill two 11/16 inch (.6875 inch) holes (1) and one 11/4 inch (1.25 inch) hole (2)
as shown on side of transmission tunnel.
(4)
De-burr panel.
(5)
Remove front passenger seat to expose battery box.
3
(7)
Drill 3/4 inch hole in rear battery box panel near top inboard edge.
(8)
Install grommet (4).
4
2-1.1
Installation of Air Conditioning Kit to M998 and M998A1; M1037; M1097 and M1097A1
with GSIE Add-on-Armor (Cont’d).
b. Install Evaporator and Condenser
(1)
If present, remove plywood panel from between seats on top of transmission tunnel.
(2)
Remove top screws from driver’s side mats and transmission tunnel.
Figure 2-10.
Transmission Tunnel Hole
Figure 2-11.
Auxiliary Power Panel
Figure 2-12.
Battery Box Panel Hole
(6)
Remove either auxiliary power panel (3) or batteries to gain access to drill hole in battery
box.
Back to Top
