TB-9-2510-251-13
TECHNICAL BULLETIN
OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING
AUGUST 2007
TB-9-2510-251-13 - Page 33 of 624
2-17
TB 9-2510-251-13
(28)
Four-door vehicles only:
a. Drill a 1.25 inch diameter hole (38) for condenser hose in bed floor between wheel well
and driver side vertical condenser mount angle, forward of rear curtain hook.
b. De-burr hole.
2-1.1
Installation of Air Conditioning Kit to M998 and M998A1; M1037; M1097 and M1097A1
with GSIE Add-on-Armor (Cont’d).
b. Install Evaporator and Condenser (Cont’d)
38
32
33
32
35
34
36
37
32
Figure 2-23.
Evaporator Side Brackets
Figure 2-24.
Condenser Hose Hole (Four-Door)
(24)
Remove two top center bolts from rear center armor plate and rear side armor plate.
(25)
Loosely attach evaporator side brackets (32) to evaporator unit with original hardware.
(26)
Position condenser mount angles over top slots in rear center armor plate.
(27)
Install bolts (33) flat washers (34), and oversize washers (35) through evaporator side
brackets (32), armor plates, rear curtain, and condenser mount angles, and secure with flat
washers (36) and locknuts (37).
Tighten snug.
Back to Top
