TB-9-2510-251-24
TECHNICAL BULLETIN
INSTALLATION, REMOVAL, AND PARTS INSTRUCTIONS FOR ADD ON ARMOR (AOA) AND ASSOCIATED COMPONENTS FOR HMMWV FAMILY OF VEHICLES (FOVs)
JULY 2005
TB-9-2510-251-24 - Page 95 of 212
TB 9-2510-251-24
2-23
3)
Remove B-partition assemblies as follows (see figure 2-20):
a.
Remove four capscrews (3), washers (4) and locking nuts (5) securing right and left B-partition assemblies (10 and
2), upper gap strip (11) and lower gap strip (6) to right and left B-partition mount brackets.
Discard locking nuts
(5).
b.
Remove 12 capscrews (1), washers (7) and locking nuts (8) disassembling upper gap strip (11) and lower gap strip
(6) from right and left B-partition assemblies (10 and 2).
Discard locking nuts (8).
c.
Peal up B-partition rubber strip (9) from vehicle tunnel.
Discard used rubber strip.
LEFT
B-PARTITION
MOUNT
BRACKET
(REF)
RIGHT
B-PARTITION
MOUNT
BRACKET
(REF)
B-PILLAR
(REF)
1
2
3
4
5
6
1
3
7
8
7
8
4
5
9
11
10
VEHICLE
TUNNEL
(REF)
Figure 2-20.
B-Partition Removal
(2 Door Only)
Back to Top
