TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 437 of 704
TB 9-3950-253-13&P
0046-1
0046
FIELD MAINTENANCE
-
STOWAGE ANGLE SENSOR CALIBRATION
WARNING
•
Lift frame must be placed on solid, level ground with adequate support from stands.
•
During these procedures, the operator will be required to climb on and around the vehicle.
Be sure to wear suitable footwear and that no surfaces are slippery. Wear suitable gloves
and hard hat.
•
Failure to follow these warnings may result in injury or death to personnel.
INTRODUCTION
00046
This procedure calibrates the operating range of the stowage angle sensor.
INITIAL SETUP
Tools and Special Tools
0
Tool Kit, General Mechanic’s (WP 0057, Item
2)
0
Tool Set, SATS Base (WP 0057, Item 3)
0
Materials/Parts
0
Cap Set, Protective, Dust and Moisture (WP
0060, Item 3)
0
Rag, Wiping (WP 0060, Item 10)
0
Tag, Marker (WP 0060, Item 12)
0
Locknut (WP 0060, Item 12) (3)
0
Personnel Required
0
Two
0
References
0
WP 0020
0
Equipment Condition
0
Vehicle parked on level ground, in neutral gear
with parking brake applied (PLS: TM 9-
2320-364-14&P HEMTT: TM 9-2320-326-
14&P)
0
Lift frame placed on level ground (WP 0007)
0
Stowage control panel toggle switch set to
OFF position (WP 0004)
0
8
Back to Top
