TM-1-1500-344-23-4
CONSUMABLE MATERIALS AND EQUIPMENT FOR AIRCRAFT AND AVIONICS VOLUME IV
TECHNICAL MANUAL; CLEANING AND CORROSION CONTROL
SEPTEMBER 2013
TM-1-1500-344-23-4 - Page 22 of 92
2-14
NAVAIR 01-1A-509-4
TM 1-1500-344-23-4
01 September 2013
Table 2-7. Lubricants
Nomenclature
Specifcation/
Part No.
National Stock
Number
Unit of
Issue
Intended Use
Usable
On
AC AV
Grease, Aircraft,
General Purpose,
Wide Temperature
Range, NATO Code
G-395
MIL-PRF-81322
TU (8 OZ)
CA (14 OZ)
CN (1.75 LB)
Lubricating aircraft wheel bearings and
internal brake wheel assemblies, anti-
friction bearings, gearboxes, and plain
bearings.
X
Grease, Aircraft and
Instrument
MIL-PRF-32014
TU (2 OZ)
TU (4 OZ)
CA (14 OZ)
JR (1.75 LB)
CN (6.5 LB)
General purpose aircraft lubricant that
provides water resistance and corrosion
protection over an extended period.
X
X
Grease, Aircraft and
Instrument, Gear and
Actuator Screw,
NATO Code G-354
MIL-PRF-23827
Type I
Type II
TU (4 OZ)
TU (8 OZ)
CA (14 OZ)
CN (1.75 LB)
CN (6.5 LB)
CN (35 LB)
CA (14 OZ)
CN (6.5 LB)
Lubrication of ball, roller and needle
bearings, gears and sliding and
rolling surfaces of such equipment as
instruments, cameras, electronic gear
and aircraft control systems that are
subject to extreme marine and low
temperature conditions. Also intended for
general use on aircraft gears, actuator
screws, and other equipment requiring a
lubricant with high load carrying capacity.
X
X
Grease, Plug Valve,
Gasoline, Oil, and
Water Resistant,
NATO Code G-363
AMS-G-6032
(supersedes MIL-G-6032)
Type I (Bulk)
Type II (Cylindrical sticks)
Class A (1/4"D x 7/8"L)
Class B (13/32"D x 1-3/8"L)
Class C (35/64"D x 2"L)
Class D (21/32"D x 2-7/16"L)
Class G (55/64"D x 3-3/8"L)
CN (8 OZ)
CN (1.75 LB)
BX (24 EA)
BX (24 EA)
BX (24 EA)
BX (24 EA)
BX (24 EA)
Lubrication of tapered plug valves. Also
may be used as a gasket lubricant or
seal, and for general plug valve service
in systems where gasoline, oil, alcohol,
or water resistance is required.
X
Grease, Aircraft and
Instrument, Fuel and
Oxidizer Resistant,
NATO Code G-399
MIL-PRF-27617
Type I
(-65°F to 300°F)
Type III
(-30°F to 400°F)
TU (8 OZ)
CN (1.75 LB)
TU (8 OZ)
CN (1.75 LB)
Lubrication of taper plug valves, gaskets,
and bearings in fuel systems of aircraft
and ground support equipment. Also
suitable for use in liquid oxygen systems
as a lubricant for valves, threads, and
bearings in aerospace vehicles and
supporting equipment. May not be
suitable for aluminum and magnesium
dynamic bearing lubrication because of
possible ignition hazards. Commonly
known as "Krytox".
X
Grease, Molybdenum
Disul±de, Low and
High Temperatures,
NATO Code G-353
MIL-G-21164
CA (14 OZ)
CN (1.75 LB)
CN (6.5 LB)
CN (35 LB)
Lubricant for accessory splines, heavy
loaded sliding steel surfaces, or for
anti-friction bearings carrying high loads
and operating through wide temperature
ranges where molybdenum disul±de will
prevent or delay seizure in the event of
inadequate lubrication. Do not use on
wheel bearings or non-steel surfaces
without authorization.
X
Grease, Pneumatic
System,
NATO Code G-392
AMS-G-4343
(supercedes MIL-G-4343)
TU (2 OZ)
CN (1.75 LB)
Lubricant between rubber and metal
parts of pneumatic systems. It may also
be used for pressurized cabin bulkhead
grommets and other mechanisms
requiring rubber to metal lubrication.
X
Back to Top
