TM-10-5411-205-13
SHELTER, ELECTRICAL EQUIPMENT - 250/G
TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT MAINTENANCE MANUAL
MAY 1995
CHANGE 2
TM-10-5411-205-13 - Page 16 of 127
Item
4
5
6
10
11
TM 10-5411-205-13
Table 2-1. Operator Preventive Maintenance Checks and Services (cont).
Item to be
Inspected
Door Assemblies,
Inner and Outer
(rent)
Lifting and Tow-
ing Bracket
Assemblies
Roof Access Steps
Roof Handle
Drain Plug
RFI/EMI
Components
Wall Floor, and
Ceiling Panels
skids
Procedures
Check for and have repaired
or adjusted as necessary
c. Make sure troughs (drip
moldings) above each door are
mounted securely.
d. Check door surfaces for
punctures.
e. Make sure weather gaskets
are in good condition.
a Inspect for excessive wear.
b. Inspect for rust, loose or
missing hardware.
c. Make sure rings and pins
rotate freely.
a. Make sure steps stay in up
or down position as required.
b. Check for loose or missing
hardware.
Make sure handle is securely
mounted to roof.
Make sure drain plug is in
place.
a Make sure metal door
gaskets are complete and intact
b. Make sure filter is in
place and undamaged.
Inspect for punctures and
delamination.
Make sure skids are securely
mounted to shelter and are
undamaged.
Item is
Not Ready/
Available if:
Drain plug is miss-
ing (shielded
shelters).
a. Gasket is not
intact.
b. Filter is not
intact.
Punctures are
present.
2-3
Back to Top
