TM-5-2350-262-20-1

ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL; VOLUME 1 OF 3

TM-5-2350-262-20-1 - Page 558 of 776

TM 5-2350-262-20-1

Change 4

4-210.3

I

Connect wire rope (6) to wedge (13) and insert

wedge (13) into nut (12).

J

Secure nut (12) inside fire extinguisher handle

(14).

K

Route antipilferage seal (17) through fire extin-

guisher handle (14) and tab (18) on vehicle hull

and secure ends of antipilferage seal (17).

L

Install cotter pin (19) through actuator arm (3) to

prevent accidental discharge of fire extinguisher

cylinder during installation.

A

Install pivot (1) through base plate (2).

B

Install actuator arm (3) on pivot (1) with roll pin

(4).

C

Install straight adapter (5) on base plate (2), en-

sure proper orientation to assembly as shown.

D

Route wire rope (6) through end of actuator arm

(3), base plate (2), straight adapter (5), and cable

sheath (8).

E

Install reducer (9) through hull with nut (10) and

stamped nut (11).

F

Route wire rope (6) through reducer (9) and nut

(12).

G

Install both ends of cable sheath (8) to straight

adapter (5) and reducer (9), respectively.

H

Pull and measure distance of wire rope (6) from

mating surface (15) of reducer (9) to mating sur-

face (16) of fire extiniguisher handle (14).

Mea-

surement should not exceed 2 inches (5.08 cm).

Note

Wire rope is routed the same way as re-

moved.

INSTALLATION (LEFT SIDE)

FOLLOW-ON TASKS:

Install actuator assembly and base plate on fire

extinguisher cylinder (Page 4-212.1).

Close engine grills and access covers (TM 5-

2350-262-10).