TM-5-2350-262-20-1

ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL; VOLUME 1 OF 3

TM-5-2350-262-20-1 - Page 559 of 776

TM 5-2350-262-20-1

4-210.4

Change 4

F

Remove four self-locking screws (10) and wash-

ers (11) from access cover (12) and gasket (13).

Discard self-locking screws (10).

G

Remove stamped nut (14) and nut (15) from re-

ducer (9).

H

Remove roll pin (16) from pivot (17) and remove

actuator arm (2) from pivot (17) and base plate

(18).

I

Remove cable sheath (8) from straight adapter

(19).

J

Remove straight adapter (19) from base plate

(18).

K

Pull wire rope (7) through nut (5), reducer (9),

gasket (13), access cover(12),

nut (15), stamped

nut (14), cable sheath (8), straight adapter (19),

base plate (18), and actuator arm (2).

Discard

gasket (13).

WARNING

Do

not

breathe

fire

extinguisher vapors.

Failure

to comply may result in injury

to personnel.

A

Remove cotter pin (1) from actuator arm (2).

B

Cut and remove antipilferage seal (3) and pull

fire extinguisher handle (4) outward from hull.

Discard antipilferage seal (3).

C

Remove nut (5) from fire extinguisher handle (4)

and pull wedge (6) and wire rope (7) free of nut

(5).

D

Remove wedge (6) from wire rope (7).

E

Remove cable sheath (8) from reducer (9).

Note

To remove wire rope it is necessary to re-

move the fire extinguisher handle nut and

wedge.

Note

Notice the routing of the wire rope to facilitate

reassembly.

REMOVAL (RIGHT SIDE)

15

3

1

2

7

8

19

17

16

7

4

13

1

8

14

9

6

5

4

7

18

OUTSIDE

HULL

10

11

13

12