TM-5-2350-378-24-P
HYDRAULIC DIAGNOSTIC CENTER (HDC) SUPPORTING ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
TM-5-2350-378-24-P - Page 589 of 790
TM 5--2350--378--24&P
0034 00--4
REPLACE HDC PRIMARY MANIFOLD ASSEMBLY AND MOUNTING BRACKET --
Continued
0034 00
INSTALLATION
WARNING
S
Do not operate ejector when personnel are in bowl. Do not work in bowl unless
ejector lock is engaged. Failure to comply may result in severe injury or death to
personnel.
S
Do not stand or work in bowl area unless ejector lock is engaged. Do not stand in
bowl to observe roller guide travels. Failure to comply may result in severe injury
or death to personnel.
S
When folding dozer blade, work on blade latches from side of vehicle only. Do not
stand In front of dozer blade while retracting ejector. Failure to comply may result
in severe injury or death to personnel.
1.
Install mounting plate (Figure 3, item 1) on primary manifold (Figure 3, item 4) with four flat washers
(Figure 3, item 14) and four new self--locking screws (Figure 3, item 15).
2.
Supporting weight of primary manifold (Figure 3, item 4), install primary manifold (Figure 3, item 4) with
seven flat washers (Figure 3, item 3) and seven new self--locking screws (Figure 3, item 2).
3.
Install hull floor support bracket (Figure 3, item 7) with three flat washers (Figure 3, item 10) and three new
self--locking screws (Figure 3, item 11).
4.
Install lateral support bracket (Figure 3, item 13) with new self--locking nut (Figure 3, item 12), three flat
washers (Figure 3, item 9), screw (Figure 3, item 8), two flat washers (Figure 3, item 5), and two new
self--locking screws (Figure 3, item 6).
Back to Top
