TM-5-2350-378-24-P

HYDRAULIC DIAGNOSTIC CENTER (HDC) SUPPORTING ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

TM-5-2350-378-24-P - Page 584 of 790

TM 5--2350--378--24&P

0033 00--5

REPAIR HDC AFT MANIFOLD ASSEMBLY -- Continued

0033 00

INSTALLATION

WARNING

Do not work under vehicle unless hull is on jack stands and apron lockpins are

installed. Failure to comply may result in severe injury or death to personnel.

NOTE

Installation steps are accomplished through

access under vehicle.

After installation is complete, remove tags from

all hydraulic lines and wiring harness leads.

1.

Install aft manifold (Figure 4, item 6) in vehicle with three new self--locking screws (Figure 4, item 4) and

three flat washers (Figure 4, item 5).

2.

Remove caps from adapters and plugs from hydraulic hose connector ends and connect six hydraulic hoses

(Figure 4, item 3) to aft manifold (Figure 4, item 6).

3.

Connect wiring harness W3 connectors P4, P6, P7, P8, and P18 (Figure 4, item 1) to five two--way valves

V4, V6, V7, V8 and V18 (Figure 4, item 2) on aft manifold (Figure 4, item 6).

4.

Remove tags from all hydraulic hoses and wiring harness W3 connectors.

Figure 4. Installing HDC Aft Manifold Assembly

END OF TASK