TM-5-2350-378-24-P

HYDRAULIC DIAGNOSTIC CENTER (HDC) SUPPORTING ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

TM-5-2350-378-24-P - Page 581 of 790

TM 5--2350--378--24&P

0033 00--2

REPAIR HDC AFT MANIFOLD ASSEMBLY -- Continued

0033 00

REMOVAL -- CONTINUED

NOTE

All removal steps are accomplished through

access under vehicle.

Tag all hydraulic lines and wiring harness leads

being disconnected to assist in installation.

1.

Remove wiring harness W3 connectors P4, P6, P7, P8, and P18 (Figure 1, item 1) from five two--way valves

V4, V6, V7, V8 and V18 (Figure 1, item 2) on aft manifold (Figure 1, item 6).

CAUTION

Cap or plug all oil port and ends of hoses and tubes when oil hoses or tubes are

disconnected or removed to prevent contamination. Failure to comply may result in

damage to equipment.

2.

Remove six hydraulic hoses (Figure 1, item 3) from aft manifold (Figure 1, item 6).

3.

Remove three self--locking screws (Figure 1, item 4), three flat washers (Figure 1, item 5), and aft manifold

(Figure 1, item 6) from vehicle.

Figure 1. Removing HDC Manifold Assembly

END OF TASK