TM-5-2350-378-24-P
HYDRAULIC DIAGNOSTIC CENTER (HDC) SUPPORTING ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
TM-5-2350-378-24-P - Page 572 of 790
TM 5--2350--378--24&P
0031 00--5
REPAIR HDC FORWARD LEFT MANIFOLD ASSEMBLY -- Continued
0031 00
INSTALLATION
NOTE
Installation steps are accomplished through ac-
cess under vehicle.
After installation is complete, remove tags from
all hydraulic lines and wiring harness leads.
WARNING
Do not work under vehicle unless hull is on jack stands and apron lockpins are
installed. Failure to comply may result in severe injury or death to personnel.
1.
Install left forward manifold (Figure 4, item 9) using two flat washers (Figure 4, item 8) and two new
self--locking screws (Figure 4, item 7).
2.
Connect wiring harness W3 connector P30 (Figure 4, item 3) to transducer T10 (Figure 4, item 4) on left
forward manifold (Figure 4, item 9).
3.
Connect wiring harness W3 connectors P3 and P9 (Figure 4, item 6) to two two--way (NO) valves V3 and V9
(Figure 4, item 5) on left forward manifold (Figure 4, item 9).
4.
Remove all caps and plugs from hydraulic fittings.
5.
Connect five hydraulic hoses (Figure 4, item 2) and three hydraulic tubes (Figure 4, item 1) to left forward
manifold (Figure 4, item 9).
Figure 4. Installing HDC Forward Left Manifold Assembly
END OF TASK
Back to Top
