TM-5-2350-378-24-P
HYDRAULIC DIAGNOSTIC CENTER (HDC) SUPPORTING ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
TM-5-2350-378-24-P - Page 564 of 790
TM 5--2350--378--24&P
0030 00--3
REPLACE WIRING HARNESS W3 -- Continued
0030 00
REMOVAL -- CONTINUED
WARNING
Do not work under vehicle unless hull is on jack stands and apron lockpins are
installed. Failure to comply may result in severe injury or death to personnel.
4.
From access under vehicle, remove the following W3 wiring harness connectors from the forward right
manifold (Figure 2, item 23): connector P2 (Figure 2, item 20) from valve V2 (Figure 2, item 21), connector
P10 (Figure 2, item 19) from valve V10 (Figure 2, item 22), and connector P11 (Figure 2, item 1) from
transducer T11 (Figure 2, item 2).
5.
From access under vehicle, remove the following W3 wiring harness connectors from the forward left
manifold (Figure 2, item 9): connector P3 (Figure 2, item 7) from valve V3 (Figure 2, item 8), connector P9
(Figure 2, item 6) from valve V9 (Figure 2, item 5), and connector P30 (Figure 2, item 4) from transducer T10
(Figure 2, item 3).
6.
From access under vehicle, remove the following W3 wiring harness connectors from the aft manifold
(Figure 2, item 12): connector P4 (Figure 2, item 25) from valve V4 (Figure 2, item 11), connector P6
(Figure 2, item 14) from valve V6 (Figure 2, item 13), connector P7 (Figure 2, item 16) from valve P7
(Figure 2, item 15), connector P8 (Figure 2, item 18) from valve V8 (Figure 2, item 17), and connector P18
(Figure 2, item 24) from valve V18 (Figure 2, item 10).
Figure 2. Accessing Wiring Harness W3 From Under Vehicle
Back to Top
