TM-5-2350-378-24-P
HYDRAULIC DIAGNOSTIC CENTER (HDC) SUPPORTING ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
TM-5-2350-378-24-P - Page 554 of 790
TM 5--2350--378--24&P
REPLACE WIRING HARNESS W1 -- Continued
0028 00
INSTALLATION
WARNING
Ensure that vehicle power is off and battery disconnected. Remove all jewelry, such
as rings, dog tags, bracelets, etc. If jewelry or disconnected battery ground cable
contacts battery positive terminal, a direct short will result, causing instant heating of
tools, tool damage, battery damage, or battery explosion. Failure to comply may
result in severe injury or death.
1.
Thread wiring harness W1 leads 1070 (Figure 2, item 3) and 1069 (Figure 2, item 11) through wire clamps to
parking brake relay and battery box.
2.
Connect wiring harness W1 connector J1 (Figure 2, item 9) to HDC disconnect bracket (Figure 2, item 7) with
nutplate (Figure 2, item 5), and four screws (Figure 2, item 6). Attach dust cap (Figure 2, item 8) to
connector J1.
3.
Install wiring harness W1 lead 1069 (Figure 2, item 11) on compartment wall above the NBC filter with bolt
(Figure 2, item 10).
4.
Install wiring harness W1 lead 1070 (Figure 2, item 3) on parking brake relay (Figure 2, item 4) with new
lockwasher (Figure 2, item 2) and screw (Figure 2, item 1).
Figure 2. Installing Wiring Harness W1
END OF TASK
FOLLOW--ON MAINTENANCE
1.
Return apron to stowed position (TM 5--2350--262--10).
2.
Return ejector to stowed position (TM 5--2350--262--10).
END OF TASK
END OF WORK PACKAGE
0028 00--3/4 blank
Back to Top
