TM-5-2350-378-24-P

HYDRAULIC DIAGNOSTIC CENTER (HDC) SUPPORTING ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

TM-5-2350-378-24-P - Page 549 of 790

TM 5--2350--378--24&P

0027 00--4

REPLACE HDC CIRCUIT BREAKER AND POWER DISTRIBUTION COMPONENTS --

Continued

0027 00

INSTALLATION

WARNING

Ensure that vehicle power is off and battery disconnected. Remove all jewelry, such

as rings, dog tags, bracelets, etc. If jewelry or disconnected battery ground cable

contacts battery positive terminal, a direct short will result, causing instant heating of

tools, tool damage, battery damage, or battery explosion. Failure to comply may

result in severe injury or death.

NOTE

Wiring connections to parking brake relay should be made using screws attached to

relay. New lockwashers should be used. If attaching screws are damaged or

missing, obtain new screws locally.

1.

Install in--line connector (Figure 3, item 3), “Y” --connector (Figure 3, item 2), and lead assemblies (Figure 3,

item 1), in right terminal or trailer receptacle and trouble light circuit breaker (Figure 3, item 4), located behind

driver’s compartment switch and gauge panel.

2.

Install lead assembly 1070 (Figure 3, item 6) on terminal B2 of parking brake relay (Figure 3, item 5) with

new lockwasher.

Figure 3. Installing Power Distribution Components