TM-5-2350-378-24-P

HYDRAULIC DIAGNOSTIC CENTER (HDC) SUPPORTING ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

TM-5-2350-378-24-P - Page 553 of 790

TM 5--2350--378--24&P

0028 00--2

REPLACE WIRING HARNESS W1 -- Continued

0028 00

REMOVAL -- CONTINUED

1.

Remove screw (Figure 1, item 1), lockwasher (Figure 1, item 2), and wiring harness W1 lead 1070 (Figure 1,

item 3) from parking brake relay (Figure 1, item 4) terminal B1.

2.

Remove bolt (Figure 1, item 10), from the compartment wall above the NBC filter and remove wiring harness

lead 1069 (Figure 1, item 11).

3.

Remove dust cap (Figure 1, item 8), four screws (Figure 1, item 6), nutplate (Figure 1, item 5) and wiring

harness W1 connector J1 (Figure 1, item 9) from HDC disconnect bracket (Figure 1, item 7).

4.

Pull wiring harness W1 leads 1070 (Figure 1, item 3) and 1069 (Figure 1, item 11) through wire clamps and

remove wiring harness W1 from vehicle.

Figure 1. Removing Wiring Harness W1

END OF TASK