TM-5-2350-378-24-P
HYDRAULIC DIAGNOSTIC CENTER (HDC) SUPPORTING ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
TM-5-2350-378-24-P - Page 567 of 790
TM 5--2350--378--24&P
0030 00--6
REPLACE WIRING HARNESS W3 -- Continued
0030 00
INSTALLATION -- CONTINUED
7.
Connect wiring harness W3 connector P31 (Figure 5, item 10) to transducer T6 (Figure 5, item 11) at forward
left actuator #1 (Figure 5, item 9).
8.
Connect wiring harness W3 connector P5 (Figure 5, item 7) to transducer T5 (Figure 5, item 6) at forward
right actuator #1 (Figure 5, item 8).
9.
Install wiring harness W3 connector J1 (Figure 5, item 2) to HDC disconnect bracket (Figure 5, item 3) with
nutplate (Figure 5, item 1), and four screws (Figure 5, item 4). Attach dust cap (Figure 5, item 5) to
connector J1.
Figure 5. Installing Wiring Harness W3 To Disconnect Bracket And Actuator Area
END OF TASK
FOLLOW--ON MAINTENANCE
1.
Install hull access plates (TM 5--2350--262--20--1).
2.
Remove vehicle from jack stands and lower hull (TM 5--2350--262--20--1).
3.
Return ejector to stowed position (TM 5--2350--262--10).
4.
Return apron to stowed position (TM 5--2350--262--10).
END OF TASK
END OF WORK PACKAGE
Back to Top
