TM-5-2350-378-24-P
HYDRAULIC DIAGNOSTIC CENTER (HDC) SUPPORTING ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
TM-5-2350-378-24-P - Page 578 of 790
TM 5--2350--378--24&P
0032 00--5
REPAIR HDC FORWARD RIGHT MANIFOLD ASSEMBLY -- Continued
0032 00
INSTALLATION
WARNING
Do not work under vehicle unless hull is on jack stands and apron lockpins are
installed. Failure to comply may result in severe injury or death to personnel.
NOTE
Installation steps are accomplished through
access under vehicle.
After installation is complete, remove tags from
all hydraulic lines and wiring harness leads.
1.
Install right forward manifold (Figure 4, item 3) using two flat washers (Figure 4, item 4) and two new
self--locking screws (Figure 4, item 5).
2.
Connect wiring harness W3 connector P11 (Figure 4, item 9) to transducer T11 (Figure 4, item 8), on right
forward manifold (Figure 4, item 3).
3.
Connect wiring harness W3 connectors P2 and P10 (Figure 4, item 7) to two two--way (NO) valves V2 and
V10 (Figure 4, item 6), on right forward manifold (Figure 4, item 3).
4.
Remove all caps and plugs from hydraulic fittings.
5.
Connect five hydraulic hoses (Figure 4, item 1) and three hydraulic tubes (Figure 4, item 2) to right forward
manifold (Figure 4, item 3).
Figure 4. Installing HDC Forward Right Manifold
END OF TASK
Back to Top
