TM-5-3805-254-14-P-2

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)

JUNE 1980

TM-5-3805-254-14-P-2 - Page 217 of 894

BRAKES-AIR

MOTOR TRUCK SERVICE MANUAL

c.

Proper meshing of the pawl and sleeve

teeth can be checked at this point.

Grease coat

adjusting bolt threads and thread it into the adjusting

sleeve until it bottoms.

A clicking sound and a ratcheting

feel will indicate meshing of the teeth.

Turn the bolt out

three turns, if there is no clicking sound or ratcheting

feel, this indicates proper meshing.

Remove adjusting

bolt after check.

Tighten hollow capscrew to 15-20 ft.

lbs.

torque.

d.

Pack a small amount of grease into

underside of seal and seal lips.

Assemble the plunger

seal over the adjusting sleeve in the plunger housing by

pushing the seal over end of adjusting sleeve so the

inner lip enters seal groove.

Check by lightly pulling up

on seal.

e.

Using the proper tool seat the seal into the

plunger housing as in paragraph "2b"