TM-5-3805-264-13-P

TRUCK, DUMP, HEAVY, BODY M917A1 AND M917A2

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2014

TM-5-3805-264-13-P - Page 348 of 660

INSTALLATION

WARNING

Use extreme care when handling heavy parts. Lifting cables, chains, hooks, and slings

must be in good condition and of suitable capacity. Keep clear of parts supported only by

lifting device. Failure to comply may result in personnel injury, death, and/or damage to

equipment.

NOTE

Use antiseizing tape on all pipe threads (WP 0072).

1.

Install hydraulic pump (Figure 2, Item 5) on PTO (Figure 2, Item 21) with four screws (Figure 2, Item 1),

washers (Figure 2, Item 2), and nuts (Figure 2, Item 3).

2.

Install support bracket (Figure 2, Item 7) on transmission housing (Figure 2, Item 14) with two screws

(Figure 2, Item 10). Torque screws to 70–80 lb-ft (95–108 N•m).

3.

Install washer (Figure 2, Item 8) and nut (Figure 2, Item 9) on stud (Figure 2, Item 6) of hydraulic pump

(Figure 2, Item 5).

4.

Install elbow (Figure 2, Item 16) on control valve (Figure 2, Item 4).

5.

Connect hose (Figure 2, Item 15) to elbow (Figure 2, Item 16).

6.

Install adapters (Figure 2, Items 17 and 20) on control valve (Figure 2, Item 4).

7.

Connect hoses (Figure 2, Items 18 and 19) on adapters (Figure 2, Items 17 and 20).

8.

Install adapter (Figure 2, Item 13) to hydraulic pump (Figure 2, Item 5).

9.

Connect suction hose (Figure 2, Item 12) to adapter (Figure 2, Item 13) and tighten clamp

(Figure 2, Item 11).

TM 5-3805-264-13&P

0059

0059-4