TM-5-3805-264-13-P
TRUCK, DUMP, HEAVY, BODY M917A1 AND M917A2
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JUNE 2014
TM-5-3805-264-13-P - Page 357 of 660
ASSEMBLY - Continued
NOTE
Ensure that stud is installed in correct location as noted in disassembly.
12.
Install three screws (Figure 10, Item 1), three washers (Figure 10, Item 2), stud (Figure 10, Item 3), washer
(Figure 10, Item 2), and nut (Figure 10, Item 4) in place to secure pump housings. Tighten screws and stud
in crisscross pattern and torque to 200 lb-ft (271 N•m). Check for free shaft movement by turning drive shaft
with a wrench.
13.
Install one washer (Figure 10, Item 2) and nut (Figure 10, Item 4) on stud (Figure 10, Item 3) and tighten by
hand.
Figure 10.
Pump Hardware Installation.
14.
Install seal retainer (Figure 11, Item 3), spacer (Figure 11, Item 2), and new retaining ring (Figure 11, Item 1)
on drive shaft (Figure 11, Item 4).
Figure 11.
Drive Shaft Retaining Ring Installation.
END OF TASK
FOLLOW-ON MAINTENANCE
Install hydraulic pump (WP 0059).
END OF TASK
END OF WORK PACKAGE
TM 5-3805-264-13&P
0060
0060-7/blank
Back to Top
