TM-5-3805-264-13-P
TRUCK, DUMP, HEAVY, BODY M917A1 AND M917A2
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JUNE 2014
TM-5-3805-264-13-P - Page 351 of 660
FIELD MAINTENANCE
HYDRAULIC PUMP REPAIR
INITIAL SETUP:
Tools and Special Tools
General Mechanic's Tool Kit
(WP 0113, Table 1, Item 12)
Machinist’s Vise (WP 0113, Table 1, Item 14)
Socket Wrench Set: 3/4 in. drive
(WP 0113, Table 1, Item 10)
Torque Wrench, 3/4 in. drive, 0–600 ft-lb
(0–813 N•m) (WP 0113, Table 1, Item 17)
Materials/Parts
Bearing, Roller Qty: 2
(WP 0114, Table 1, Item 9)
Gasket (Ring Seal) Qty: 2
(WP 0114, Table 1, Item 8)
Grease, Ball Bearing (WP 0112, Table 1, Item 12)
Lubricating Oil (WP 0112, Table 1, Item 23)
Seal, Nonmetallic (Pocket Seal) Qty: 12
(WP 0114, Table 1, Item 15)
Materials/Parts (cont.)
Seal, Plain (Gasket) Qty: 2
(WP 0114, Table 1, Item 11)
Seal, Plain Encased (Lip Seal)
(WP 0114, Table 1, Item 10)
Rag, Wiping (WP 0112, Table 1, Item 29)
Ring, Retaining (WP 0114, Table 1, Item 29)
Valve, Check (Check Assembly) Qty: 2
(WP 0114, Table 1, Item 17)
References
WP 0072
Equipment Condition
Hydraulic pump removed (WP 0059)
WARNING
•
Use extreme care when handling heavy parts. Lifting cables, chains, hooks, and
slings must be in good condition and of suitable capacity. Keep clear of parts
supported only by lifting device.
•
Eye protection must be worn when removing or installing snap rings or retaining
rings.
•
Failure to comply may result in personnel injury, death, and/or damage to
equipment.
CAUTION
Remove dirt from outside of hydraulic pump. Perform repair in a clean work area to prevent
contaminants from causing equipment failure. Failure to comply may result in damage to
equipment.
NOTE
Mark castings of pump to aid in assembly.
TM 5-3805-264-13&P
0060
0060-1
Back to Top
