TM-5-3805-264-13-P

TRUCK, DUMP, HEAVY, BODY M917A1 AND M917A2

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2014

TM-5-3805-264-13-P - Page 353 of 660

DISASSEMBLY - Continued

4.

Place hydraulic pump on clean, flat surface and separate end housing (Figure 3, Item 5) from gear housing

(Figure 3, Item 1).

5.

Remove drive shaft (Figure 3, Item 3) and gearshaft (Figure 3, Item 2) from end housing (Figure 3, Item 5).

6.

Remove thrust plate (Figure 3, Item 4) from end housing (Figure 3, Item 5). Remove six pocket seals

(Figure 3, Item 6) from thrust plate. Discard pocket seals.

Figure 3.

Drive Shaft Removal.

7.

Remove two check assemblies (Figure 4, Item 5) from end housing (Figure 4, Item 3). Discard check

assemblies.

8.

Remove two roller bearings (Figure 4, Item 1), ring seals (Figure 4, Item 2), and lip seal (Figure 4, Item 4)

from end housing (Figure 4, Item 3). Discard roller bearings, ring seals, and lip seal.

Figure 4.

Check Assemblies and Roller Bearings Removal.

TM 5-3805-264-13&P

0060

0060-3