TM-5-3805-264-13-P

TRUCK, DUMP, HEAVY, BODY M917A1 AND M917A2

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2014

TM-5-3805-264-13-P - Page 352 of 660

DISASSEMBLY

1.

Remove retaining ring (Figure 1, Item 1), spacer (Figure 1, Item 2), and seal retainer (Figure 1, Item 3) from

drive shaft (Figure 1, Item 4). Discard retaining ring.

Figure 1.

Drive Shaft Retaining Ring Removal.

2.

Secure hydraulic pump in vise and remove three screws (Figure 2, Item 1), two nuts (Figure 2, Item 4), and

five washers (Figure 2, Item 2) securing pump housings.

NOTE

Note stud location for assembly.

3.

Remove stud (Figure 2, Item 3).

Figure 2.

Pump Hardware Removal.

CAUTION

Internal surfaces and parts of hydraulic pump are machined to strict manufacturing

tolerances. Care must be taken not to damage machined surfaces. Failure to comply may

result in damage to equipment.

NOTE

Drive shaft and gearshaft may slide out with end housing.

TM 5-3805-264-13&P

0060

0060-2