TM-5-3805-264-13-P

TRUCK, DUMP, HEAVY, BODY M917A1 AND M917A2

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2014

TM-5-3805-264-13-P - Page 355 of 660

CLEANING AND INSPECTION

Clean and inspect components in accordance with General Maintenance Instructions (WP 0072) and the

following:

•

Inspect drive shaft and gearshaft for scoring or grooving on teeth. Any scoring, grooving, or burring of

outside diameter of teeth requires replacement of shafts as a set. If shafts are replaced, roller bearings

must also be replaced.

•

Inspect thrust plates for wear, pitting, or discoloration. If found, replace thrust plates.

END OF TASK

ASSEMBLY

WARNING

Eye protection and gloves must be worn when using grease or lubricating oils. Failure to

comply may result in personnel injury.

NOTE

Apply a light coat of lubricating oil to surfaces of components as they are assembled.

1.

Press two new ring seals (Figure 7, Item 2) and new roller bearings (Figure 7, Item 1) into end housing

(Figure 7, Item 3).

2.

Press new lip seal (Figure 7, Item 4) into drive shaft side of end housing (Figure 7, Item 3).

3.

Install two new check assemblies (Figure 7, Item 5) on end housing (Figure 7, Item 3).

Figure 7.

Check Assemblies and Roller Bearings Installation.

TM 5-3805-264-13&P

0060

0060-5