TM-5-3990-263-13-P
PALLET, ADAPTER, BRIDGE, M15
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
APRIL 2012
TM-5-3990-263-13-P - Page 474 of 728
REMOVAL - Continued
19
20
19
22
25
23
26
17
18
24
22
21
16
18
17
26
Figure 3.
Lower Cable Guide Shaft Removal.
6.
Remove six screws (Figure 3, Item 23), nuts (Figure 3, Item 24), two upper cable guide retainers (Figure 3,
Item 18), and roller assembly (Figure 3, Item 25) from carriage (Figure 3, Item 21). Remove two grease fittings
(Figure 3, Item 26) from roller assembly (Figure 3, Item 25).
NOTE
•
When replacing an old winch assembly with a new winch assembly, remove eight bolts
from new winch assembly and exchange with those on winch being turned in for repair.
Bolts used to mount pivot plates are longer than those shipped with new winch assembly.
Be sure to ship old winch with all shorter bolts.
•
Replace the two pivot plates one at a time.
7.
Remove four bolts (Figure 4, Item 27) and lockwashers (Figure 4, Item 28) from each of two pivot plates (Figure
4, Item 22). Remove two pivot plates (Figure 4, Item 22) from winch assembly (Figure 4, Item 29). Discard
lockwashers. Temporarily reinstall four bolts (Figure 4, Item 27) in winch assembly (Figure 4, Item 29).
TM 5-3990-263-13&P
0058
0058-4
Back to Top
