TM 5-5420-202-20-2
CYLINDER HEAD AND OIL PAN DRAIN TUBES (LEFT AND RIGHT) REPLACEMENT
(Sheet 4 of 4)
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
Position two bolts and washers (H) through lower drain tube end and place new gasket
(J) over bolts.
Using 1/2 inch socket, tighten two bolts and washers (H) to engine.
Using screwdriver, tighten 16 clamps (B) on hoses (A) and (C) on each end of
lower drain lines assembly.
Holding nut with 3/8 inch wrench and using screwdriver, connect four fuel line clamps
(J) to oil drain line.
Install left oil cooler frame and brackets (page 6-131) (as required).
Install right oil cooler frame and brackets (page 6-121) (as required).
Replenish engine oil (LO 5-5420-202-12).
Connect powerplant test (ground hop) equipment (page 5-25).
Start engine and check for leaks.
Disconnect powerplant test (ground hop) equipment (page 5-40).
Install powerplant (page 5-14).
End of Task
6-138