TM 5-5420-202-20-2
ACCELERATOR CONTROL ROD REPLACEMENT (Sheet 2 of 5)
2.
Using retaining ring pliers, remove two
retaining rings (B) from grooves (C)
in control rod (D).
3.
Remove housing (E) from control
rod (D).
4.
5.
6.
7.
8.
Using 7/16 inch socket, remove three
screws (F) and lockwashers (G).
Using 9/16 inch socket, remove two
screws (H), lockwashers (J), flat washers
(K), and shim (L) (if so equipped).
Remove housing (M) from control rod (D).
Using hammer and drive punch, remove
bushings (N) from housings (E) and (M).
Using hammer and drive punch, tap
control rod (D) out of link (P) and
pedal (Q).
Go on to Sheet 3
7-309