TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 688 of 734

TM 5-5420-202-20-2

TRANSMISSION SHROUDS REPLACEMENT (Sheet 6 of 8)

Lower Shroud Replacement (Sheet 1 of 2)

TOOLS:

1/2 in. socket with 1/2 in. drive

Ratchet with 1/2 in. drive

1/2 in. combination box and open end wrench

6 in. flat-tip screwdriver

2 in. flat-tip screwdriver

PRELIMINARY PROCEDURES:

Remove powerplant (page 5-2).

Remove engine shroud (page 9-30).

Remove generator air exhaust pipe and hose (page 10-14)

(right side only).

NOTE

NOTE

When lower shroud is removed, a grommet

Replacement of right and left lower shrouds

(A) is similar.

Left lower shroud (A) is shown.

(G) may come out with it or stay on fuel

return Iine.

REMOVAL:

1.

2.

3.

4.

5.

6.

Using 2 inch screwdriver, remove screw

(B).

Using 6 inch screwdriver, remove screw

(C).

Using socket or wrench, remove three

screws and washers (D).

Using socket or wrench, remove screw

and washer (E) securing clamp (F).

Remove lower shroud (A). Be careful

not to damage fuel return line when

removing shroud (A).

Inspect grommet (G) for tears or deterioration.

Replace if defective.

Go on to Sheet 2

9-27