TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 336 of 1060

TM 5-5420-202-20-3

ENGINE WIRING HARNESS REPLACEMENT (Sheet 8 of 12)

2.

3.

Place cable (B) in position on

starter (C) as shown.

Using flat-tip screwdriver, install

screw (D) securing cable (B) to

starter (C).

5.

8.

Place cable (E) in position on

starter solenoid (F).

Place two other cables (G) on starter

solenoid (F).

Using 3/4 inch wrench, install nut

and lockwasher (H).

Using spanner wrench, connect

connector (J) to low voltage

protection device (K).

Install two new cable ties (L)

around cables (B, E and G).

Go on to Sheet 9

Place connector (M) to ignition unit (N).

Place cable (P) and clamp (Q) in

position.

Using 7/16 inch socket, install two

screws and lockwashers (R) securing

cable (P) and clamp (Q).

Place clamp (S) (hidden) in position over

cables.

Using 1/2 inch socket, install nut

securing cables and clamp (S).

TA249234

10-293