TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 613 of 1060

TM 5-5420-202-20-3

FINAL DRIVE ADAPTER ASSEMBLY AND OIL SEAL REPLACEMENT (Sheet 2 of 2)

INSTALLATION:

1.

Position seal (A) in vehicle.

2.

Make sure that rubber lip of seal (A)

is toward inside of vehicle hull.

3.

Using hammer (B) and block of wood (C),

tap seal (A) into place.

NOTE

Seal is seated when tapped in as far as it will go.

4.

Make sure that all sand, grit, and accumulated

debris has been removed from the final drive

adapter assembly (D).

End of Task

12-8

5.

6.

7.

8.

Apply grease inside final drive adapter

assembly (D) and on final drive asselmbly

input shaft spline (E).

Using oil, lightly coat outside surface of final

drive adapter assembly (D).

Alining internal splines in final drive adapter

assembly (D) with splines on input shaft (E),

slide final drive adapter assembly (D) onto

input shaft and into seal (A).

Install powerplant (page 5-14).

TA249376