TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 666 of 1060

TM 5-5420-202-20-3

MASTER BRAKE CYLINDER MOUNTING BRACKET, TIE ROD, PUSH ROD, CLEVIS, AND

BOOT REPLACEMENT (Sheet 7 of 9)

INSTALLATION:

1.

2.

3.

4.

5.

Using vise with copper caps on vise

jaws, place clevis (A) in vise.

NOTE

Clevis (A) and nut (B) have left hand

threads.

Nut (C) and push rod (E)

have right hand threads.

Using 11/16 inch wrench, install nuts

(B) and (C) on tie rod (D) about 1-1/2

inches apart as shown.

NOTE

Nuts (B) and (C) will be tightened

during adjustment procedures.

Using 5/8 inch wrench, assemble tie rod (D), push rod (E), and clevis (A).

Apply adhesive to groove (F) on push rod (E). When adhesive becomes tacky to the touch,

install boot (G) with the drain hole in the lowest position.

Remove clevis (A) and assembled parts (B), (C), (D), (E), and (G), from vise. Race bracket

(H) in vise. Install clevis (A) and assembled parts through hole in bracket as shown.

Go on to Sheet 8

TA249415

13-25