TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 677 of 1060

TM 5-5420-202-20-3

BRAKE PRESSURE GAGE, TUBE ASSEMBLY, REDUCER, AND GASKET REPLACEMENT

(Sheet 2 of 7)

REMOVAL:

1.

2.

3.

4.

5.

6.

WARNING

Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away from flames,

sparks, or heat. Do not smoke while using. Prevent contact with eyes, mouth, and/or skin. Wear

rubber gloves when performing cleaning procedures.

Using dry cleaning solvent and rags,

clean master cylinder (A), brake tube

(B), tube nuts (C) and (D), elbow (E),

and brake pressure gage as-

sembly (F).

Using hands, place funnel and container

under tube nut (D) to catch

brake fluid.

Using 1-1/8 inch socket, remove filler

cap (G) from master cylinder (A).

Using 3/4 inch wrench to hold reducer (H), use 9/16 inch wrench to

After brake fluid has drained from master cylinder (A), use fingers

(G) to master cylinder.

remove tube nut (D).

to install filler cap

Using 3/4 inch wrench, remove reducer (H) and gasket (J). Throw gasket (J) away. Plug

hole with plastic plug.

Go on to Sheet 3

13-36