TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 680 of 1060

TM 5-5420-202-20-3

BRAKE PRESSURE GAGE, TUBE ASSEMBLY, REDUCER, AND GASKET REPLACEMENT

(Sheet 5 of 7)

INSTALLATION:

1.

Using fingers, install nut (A) to elbow (B). Install packing (C) above nut (A) and install

elbow (B) to gage (D).

2.

Using 11/16 inch wrench, tighten nut (A) while holding gage (D).

3.

Using 1/2 inch wrench, tighten elbow (B)

while holding nut (A) with 11/16 inch wrench,

Aline elbow (B) toward year of gage as shown.

4.

Using hands, place gage (D) behind bracket.

assembly (E) and aline four screw holes.

5.

6.

7.

Using screwdriver, install four screws (F)

through holes in bracket assembly (E) to

secure gage (D) to bracket assembly (E).

Using fingers, remove protective covering,

rags or tape from brake tube assembly (H)

ends.

Using fingers, install tube nut

(G) and brake tube assembly (H) finger tight

to elbow (B).

Go on to Sheet 6

13-39