TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 711 of 1060

TM 5-5420-202-20-3

BRAKE CONTROL HOUSING REPAIR (Sheet 7 of 14)

CLEANING AND INSPECTION:

WARNING

Dry cleaning solvent P-D-680 is toxic and flammable.

To prevent personal injury, wear

protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin,

eyes, and clothes and don’t breathe vapors.

Do not use near open flame or excessive heat. The

flash point for Type #1 Dry Cleaning Solvent is 100°F (38°C) and for Type #2 is 138°F (50°C).

If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.

If contact with eyes is made, wash your eyes with water and get medical aid immediately.

1.

Clean all metallic parts in dry cleaning solvent.

2.

Inspect all parts for damage or wear.

3

. .

Replace all unserviceable parts.

INSTALLATION:

1.

2.

3.

4.

Install stud (A) and eight studs (B) in

housing assembly (C).

Using 15/16 inch wrench, install plug

(D) in housing assembly (C).

NOTE

If new transmission has been

installed,

remove four nuts

and lockwashers from spacer

nut (E) locations, and two

screws and lockwashers from

stud (F) locations.

Using 9/16 inch deep well socket, install

two studs (F). Using 9/16 inch socket

and torque wrench, tighten to 20-25 lb-ft

(27-34 N-m).

Using 3/4 inch socket, install four spacer

nuts (E). Using 3/4 inch socket and torque

wrench, tighten to 55-60 lb-ft (74-81

Nom).

Go on to Sheet 8

13-70