TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 714 of 1060

TM 5-5420-202-20-3

BRAKE CONTROL HOUSING REPAIR (Sheet 10 of 14)

17. Using vise and brass jaw caps press bearing (S) into lever

(T).

18.

Position lever (U) assembly on pawl (V)

and start pin (W) through pawl and lever

assembly. Position in vise and press

pin through.

19.

20.

21.

22.

Place large loop of spring (X) over end

of lever assembly (U) and other loop

over end of pawl (V).

Insert lever assembly (U) with its

through cut out in lever (Y).

NOTE

When installing lever (Y) in

housing assembly (C) make

sure alining mark (dot) on

lever (Y) is in line with wide

slot in shaft (Z).

attached parts

Slide lever (Y) with its assembled parts on

shaft (Z).

Using retaining ring pliers, install snap

ring (AA) in groove of shaft (Z).

Go on to Sheet 11

TA249457

13-73