TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 779 of 1060

TM 5-5420-202-20-3

PARKING BRAKE PAWL AND BELLCRANK ADJUSTMENT (Sheet 3 of 9)

4.

At side housing assembly, hold control (G) at flats using oPen

loosen jam nut (H) with a 15/16 in. wrench. Continue holding

nut (J) until nut bottoms on control (G). Tighten nut (H) with

CAUTION

Do not tighten nut (J) with wrench as shaft (K) to

control (G) binding will occur. Finger tighten nut

5.

Push and pull on clevis (F) to verify

shaft (K) movement is free of binding.

If free movement occurs, proceed to

next step. If binding occurs, back-off

sleeve nut (J). Visibly inspect pack-

ing (L) for damage. Refer to page 3-70

for removal procedure.

DO NOT REPLACE PACKING. When

complete, repeat step 4.

end of 9/16 in. wrench and

control (G). Finger tighten

a 15/16 in. wrench.

Go on to Sheet 4

13-138

TA249522