TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 775 of 1060

TM 5-5420-202-20-3

PARKING BRAKE CABLE ADJUSTMENT (Sheet 3 of 4)

7.

Using ruler, measure distance between

nut (L) and connector (M) after brake

cable (G) is pushed inward as far as

possible. Record reading.

8.

Pull brake cable (G) outward 3/4 inch

farther than reading taken in step 7.

NOTE

Do not change 3/4 inch position

when performing step 9.

9.

If pin cannot be freely inserted in connector

(M), using 15/16 inch wrench, loosen

two nuts (N) and adjust cable travel

maintaining distance in step 8 until

connector (M) and bellcrank (H) will

aline. Tighten two nuts (N) after inserting

pin and clip. Tighten nuts (N) to 45-

50 lb-ft (61-68 N.m).

NOTE

An interference may exist between clevis and locating

pin during this adjustment procedure.

It may be

necessary to grind clevis as shown to eliminate this

interference.

Go on to Sheet 4

13-134

TA249518