TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 768 of 1060

TM 5-5420-202-20-3

PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (REAR ONLY OF TWO-PIECE) (Sheet 6 of 6)

11. Position connector (M) in bellcrank assembly (R). Using a 9/16 inch socket and extension,

install bracket (G) to bracket assembly (S) with two screws (T) and lockwashers (U).

NOTE

Pin and clip securing connector (M) to bellcrank

(R) need not be installed until adjustment proce-

dure is performed.

CAUTION

Make sure control assembly (C) is secured to hull

wall with clamp (N) located on metal casing, 1 inch

below disconnect nut (D).

12.

Using adjustable wrench on flats of control assembly (A), and torque wrench with 7/8

inch crow foot tighten disconnect nut (D) to 35-50 lb-in (3.9 to 5.7 N.m).

13. Perform parking brake control assembly

adjustment (page 13-132).

END OF TASK

TA249511

13-127