TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 760 of 1060

PARKING BRAKE CONTROL ASSEMBLY (ENGINE COMPARTMENT) REPLACEMENT

Install bellcrank (Z) onto stud (AA).

Install two flat washers (AB) onto stud

(AA).

Install nut (AC) onto stud. Using 9/16

inch socket and torque wrench, tighten

nut (AC) to 19-21 lb-ft (26-34 Nom).

Back off nut (AC) to aline slots in nut

with hole in stud (AA).

Install cotter pin (AD) through stud

(AA) hole. Using long nosed pliers,

bend cotter pin (AD) to prevent it from

falling out.

Position both clevises (Y) to bellcrank

32.

33.

34.

29.

30.

31.

TM 5-5420-202-20-3

(Sheet 13 of 15)

Install pins (AE) and washers (AF) to

secure clevis (Y) to bellcrank (Z).

Install cotter pins (AG), through hole

in pins (

AE

).

Using long nosed pliers, bend cotter pins

(AG) to prevent them from falling out.

Using screwdriver to hold clevis (Z), use

9/16 inch crow foot and torque wrench

to tighten nuts (X) to 28-30 lb-ft

(38-41 N-m).

Position cable connector (AH) to bellcrank (Z).

Install pin (AJ) and washer (AK) through bell-

crank (Z) and cable connector (AH).

Using pliers, install cotter pin (AL) through

hole in pin (AJ). Bend cotter pin (AL) to keep

it from falling out.

Using 9/16 inch socket, install two screws (AM)

seeming bracket (AN).

Go on to Sheet 14

TA249503

13-119