TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 762 of 1060

TM 5-5420-202-10

TM 5-5420-202-20-3

PARKING BRAKE CONTROL ASSEMBLY (ENGINE COMPARTMENT) REPLACEMENT (Sheet 15 of 15)

39.

40.

41.

42.

43.

44.

45.

46.

47.

48.

49.

Position bracket (AU) on transmission stud (AV).

Install washer (AW) and nut (AX) to secure bracket (AU). Using 3/4 inch socket, tighten

nu (AX).

Using torque wrench, tighten nut (AX) to 54-59 lb-ft (72-80 Nom).

Using screwdriver to pry open, install clamp (AY) on control assembly (D).

Install screw (AZ), lockwasher (BA) and nut (BB) to secure clamp (BC) to bracket (AU).

Using 7/16 inch open end wrench to hold nut (BB) and 7/16 inch socket and torque wrench

on screw (AZ), tighten screw (AZ) to 6-8 lb-ft (8-11 N.m).

Adjust champ (AY) to allow clearance between control assembly and transmission oil filler

tube bracket.

Install washer (BD) and nut (BE) to secure

Using 3/4 inch socket, universal joint, and

clamp (AY) to stud (BF).

extension, tighten nut (BE).

Using torque wrench, tighten nut (BE) to 54-59 lb-ft (72-80 N~m).

50.

51.

Adjust clamp to maintain minimum 3/4 inch clearance between control assembly (D)

and turbocharger.

Perform parking brake pawl and bellcrank adjustment (page 13-136).

Install powerplmt (page 5-14).

End of Task

TA249505

13-121