TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 756 of 1060

13-115

TM 5-5420-202-20-3

PARKING BRAKE CONTROL ASSEMBLY (ENGINE COMPARTMENT) REPLACEMENT (Sheet 9 of 15)

2.

3.

4.

5.

6.

Position control assemblies (C and D) to transmission. Place ends with nuts (E) at brake

housings.

Position control assemblies (C and D) through holes (F) in brake housings.

Install new preformed packing into nuts (G) before installing.

While inserting control assemblies (C and D), install, loosely the following parts in the following

order: new packing with new retainer (H), nut with new packing (G), washer (J), spring

(K), and washer (L).

Continue inserting control assemblies (C and D), guide ends of rods through brake lever

(M), and loosely install nuts (N) onto rod ends. It maybe necessary to compress springs (K)

to permit rod ends to pass through brake levers (M).

Go on to Sheet 10