TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 757 of 1060

13-116

fTM 5-5420-202-20-3

PARKING BRAKE CONTROL ASSEMBLY

ENGINE COMPARTMENT) REPLACEMENT (Sheet 10 of 15)

10.

11.

12.

13.

14.

Using

Using

7.

8.

9.

Push packing with retainer (H) onto threaded

sleeve of control assembly.

Thread nut (G) onto sleeve. Finger tighten

nut (G).

Using 9/16 inch wrench on flats (B) of control

assembly, use 15/16 inch wrench to tighten nut

(E) against housing.

fingers, thread nuts (N) onto rod end until a full thread is exposed below lower nut.

9/16 inch wrench tighten nuts (N).

Push washer (J) and spring (K) downward and install new cotter pin through hole (P) in rod

end. Bend cotter pin with pliers to keep it from falling out.

Install cover (Q) with new gasket.

Using 7/16 inch socket, install eight nuts (R) with new lockwashers.

Go on to Sheet 11

TA249500