TM 5-5420-202-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 4 of 22)
7.
8.
9.
Using 9/16 inch wrench
rod end (F), use 9/16
loosen jamnut (H).
Using 9/16 inch wrench,
control rod (J) by turning
to hold steering
inch wrench to
adjust length of
steering rod end
(F) clockwise or counterclockwise until
screw (E) drops freely through clevis (G)
and steering rod end (F).
Using small gage wire, check to see if
control rod (J) is into steering rod ends (F)
and (K) past witness holes. If control rod
(J) is past witness holes in both steering
rod ends (F) and (K), go on to step 24.
control rod (J) is not past witness hole
steering rod end (K), go on to step 20.
control rod (J) is not past witness hole
steering rod end (F’), go on to step 10.
I;
in
If
in
10.
Using 9/16 inch wrench, turn steering rod end (F) clockwise until control rod (J) is
just past witness hole in steering rod end (F).
11.
Using 9/16 inch wrench to hold steering rod end (F), use 9/16 inch wrench to tighten
jamnut (H).
Go on to Sheet 5
15-34
TA249657