TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 207 of 750

TM 5-5420-228-24

CUPOLA COVER HANDLES REPLACEMENT (LATE MODEL CUPOLA) (Sheet 2 of 2)

INSTALLATION:

1.

2.

3.

4.

5.

Manually slide outside handle

(A) through cupola cover (B),

Manually install woodruff key (C).

NOTE

If only outside handle

go to step 6.

Place hook (D) and shims (E), if any,

in position on inside handle (F).

Manually install two screws (G).

Using wrench, tighten two screws (G).

was replaced,

6.

7.

8.

9.

10.

11.

Manually slide inside handle (F)

into position on shaft of outside

handle (A).

Manually install lockwasher (H)

and nut (J).

Using 15/1 6 inch socket, tighten

nut (J).

From inside vehicle, close cupola cover (B).

Have second technician hold down cover (R) from outside of vehicle while

performing next step.

Latch inside handle (F) to see that hook (D) properly contacts

locking lug (K) and seals cupola cover (B). If hook [D) does not contact lug (K)

or seal properly, add or remove shims (E) as needed between hook (D)

and reside handle (F).

End of Task

3-22

TA251423