TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 248 of 750

TM 5-5420-228-24

UNIVERSAL JOINT REPLACEMENT (Sheet 2 of 3)

6.

Using wrench, remove four screws(J)

and universal joint (K) from yoke (G).

CLEANING AND INSPECTION:

7.

Using wrench, remove four screws (J)

and universal joint (K) from yoke C).

WARNING

flammable. Use only in well ventilated areas. Keep away

Cleaning agent specified is

from flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes,

mouth, and/or skin. Wear rubber gloves when performing cleaning procedures.

1.

Clean all parts to be reused in dry cleaning solvent.

2.

Inspect all parts for damage.

Replace all unserviceable parts.

INSTALLATION:

1.

Position universal joint (A) on yoke (B)

and manually install four screws (C) in

universal joint.

2.

3.

Using torque wrench and 7/16 inch crowfoot

wrench, tighten all screws (C) in both yokes

(B and D) to 265 to 325 lb-in (30-36 NŽm).

CAUTION

Replace any screws (C) which have

been over torqued beyond 325 lb.-in.

(36 NŽm).

Go

on to Sheet

3

Position universal joint (A) on yoke (D)

and manually install four screws (C) in

universal joint (A).

TA251463

3-63