TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 253 of 750

TM 5-5420-228-24

PUMP DRIVE SHAFT UNIVERSAL JOINT REPLACEMENT AND REPAIR (Sheet 4 of 5)

ASSEMBLY:

1.

Position universal joint (O) into pump end of driveshaft assembly (H).

2.

Press two universal joint caps (P) into pump end of driveshaft assembly (H).

3.

After two universal joint caps (P) are installed, use pliers to install snap rings (N) and wrap universal

joint (O) with masking tape to prevent caps (P) from falling off universal joint (O).

4.

Position universal joint (O) into driveshaft assembly (H) and at power take off yoke (G).

5.

Press four universal joint caps (P) into the driveshaft assembly (H) and power take off yoke (G) use

pliers to install snap rings (N).

6.

Carefully reassemble driveshaft assembly (H).

Align the arrows on the drive shaft assembly (H) and

slide together, turn dust cap (M) clockwise to tighten.

Go on to Sheet 5

3-64.4

Change 3

H

M

N

O

G

O

N

P

P