TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 249 of 750

TM 5-5420-228-24

UNIVERSAL JOINT REPLACEMENT (Sheet 3 of 3)

4.

Position key (E) between front yoke (B) and shaft (F) and slide yoke (B) forward on shaft

(F) until it bottoms out.

5.

Using screw key, install setscrew (G).

6.

7.

8.

9.

Aline splines of yoke (D) and shaft

(H), and slide yoke (D) on shaft (H).

Position tube assembly (J) between yokes (B and D). Rotate yoke (B) until both universal

joints (A) are alined, then slide yoke (D) forward.

Aline holes and manually start four screws (K) on each end of tube assembly (J).

Using torque wrench and 7/16 inch crowfoot wrench, tighten eight screws (K) to 265

to 325 lb-in (30 to 36 N•m).

NOTE

Replace any screws (K) which have been over torqued

beyond 325 lb-in (36 NŽm).

10.

Lubricate

per LO 5-5420-202-12.

11.

Install universal joint cover (page 3-61).

End of Task

3-64

TA251464